mobil:parts:electronics:charger
This is an old revision of the document!
Table of Contents
charger
prototype|obsolete]
🧩 General Description
Short description: what this part does and where it’s used.
- Category: part:type:other
- Material: …
- Dimensions: …
- Weight: …
- Manufacturing: (extrusion / 3D print / woodwork / …)
- Status: in_stock / prototype / obsolete
🔧 Technical Details
| Parameter | Spec |
|---|---|
| Length | … |
| Width | … |
| Height | … |
| Diameter | … |
| Weight | … |
| Material | … |
| Fastening | (pin / screw / elastic / …) |
| Compatible with | ... |
🧱 Used In
Typical structures/modules using this part:
Charger Box
Purpose : The charger box is used to recharge the portable batteries of the Mobil system.
How to use :
Standard charge :
- Open the box
- Insert one or two batteries on their dedicated rail
- Plug the box into a 220V outlet
- Select ON with the large dial
- Wait for the batteries to charge
- Select OFF when charging is complete
Solar charge :
- Open the box
- Insert one or two batteries on their dedicated rail
- Connect the box to the solar panels (yellow connector)
- Select SOLAR with the large dial
- Wait for the batteries to charge
- Select OFF when charging is complete
Do ✅ - Always select OFF after use, otherwise the batteries will drain
Don't ❌ Never store discharged batteries — ideally store them at half charge
Circuit breaker :
- If the circuit breaker trips :
- 1. Select OFF on the large dial
- 2. Unplug the device from the 220V outlet
- 3. Press the circuit breaker button to reset it
- 4. Select ON with the large dial, then press the small ON button
🧰 Assembly & Maintenance
- Tools: …
- People: …
- Time: …
- Safety: …
- Cleaning / Storage: …
📷 Documentation
🧍 Designed By
mobil/parts/electronics/charger.1772895194.txt.gz · Last modified: by yannick